Inspection

1. Inspect roller clutch race inside center support for scratches wear or damage.

2. Inspect center support for cracks or damaged lugs.

3. Inspect oil rings and ring grooves for damage, burrs or cuts.

4. Air check oil passages, Fig. 16.

5. Inspect intermediate clutch piston for cracks or damage.

6. Inspect sealing surfaces and seal grooves for scratches or other damage.

7. Inspect springs for collapsed coils or distortion.

8. Ensure constant bleed orifice is open approximately .020 inch.

9. Inspect bushing for scoring, wear or galling. If replacement is necessary, proceed as follows:

a Using tools J-21 465-6 and J-8092, or equivalents, remove bushing

b. From front side of center support, align elongated slot in bushing with drilled hole in oil delivery sleeve closest to piston.

c. Using tools J-21 465-6 and J-8092, or equivalents, drive bushing squarely into bore until bushing is flush to .010 inch below top of oil delivery sleeve.