B1000
DTC B1000
CIRCUIT DESCRIPTION
The internal fault detection is handled inside the control module. No external circuits are involved.
DTC DESCRIPTOR
This diagnostic procedure supports the following DTC:
DTC B1000 Electronic Control Unit (ECU) Performance
This vehicle has DTCs which include DTC Symptoms. For more information on DTC Symptoms, refer to DTC Symptom Description in Vehicle DTC Information. Symptoms - Vehicle
CONDITIONS FOR RUNNING THE DTC
The module runs the program to detect an internal fault when power up is commanded. The only requirements are voltage and ground. This program runs even if the voltage is out of the valid operating range.
CONDITIONS FOR SETTING THE DTC
The module has detected an internal malfunction.
ACTION TAKEN WHEN THE DTC SETS
The module refuses all additional inputs.
CONDITIONS FOR CLEARING THE DTC
- A current DTC clears when the malfunction is no longer present in all modules.
- A history DTC clears in all of the modules except the sensing and diagnostic module (SDM), when the ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.
- If the code is set in the SDM it will never clear and the Air Bag indicator will remain illuminated.
DIAGNOSTIC AIDS
- This DTC may be stored as a history DTC without affecting the operation of a module, except the SDM. If stored only as a history DTC and not retrieved as a current DTC, do not replace the module. Attempt to clear the code from any module except if the code is set in the SDM.
- If this DTC is retrieved as both a current and history DTC, replace the module.
- If the code is set as current or history in the SDM, the SDM must be replaced.
TEST
