Speakers Inoperative - One or More

Speakers Inoperative - One or More

Diagnostic System Check - Entertainment System

Always perform the Vehicle Diagnostic System Check before proceeding with these diagnostic procedures. Refer to Diagnostic System Check - Vehicle. Initial Inspection and Diagnostic Overview

One Speaker Inoperative

Important: The following information lists the most probable cause of the concern to the least probable cause. If the list leads to the replacement of a component, always inspect for a poor connection before proceeding with replacement. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Diagnostic Aids. Component Tests and General Diagnostics

With RPO U1C

* Speaker output open-Test the appropriate speaker output circuits for an open. Refer to Circuit Testing and Wiring Repairs in Diagnostic Aids. Component Tests and General Diagnostics
* No audio output from the radio-Disconnect speaker harness connector from speaker. Turn On the radio and adjust volume approximately 50 percent. Measure the A/C voltage across the speaker harness connector terminals. Replace the speaker if A/C voltage is present.
* If no A/C voltage is present, replace the radio. Refer to Control Module References for replacement, setup, and programming.
* Perform the vehicle identification number (VIN) Relearn procedure with a scan tool. On the scan tool, go to Module Replacement/Setup in Vehicle Control Systems and select Radio.

With RPO UQ3

1. Speaker output circuit from amplifier open or shorted-Test the appropriate speaker output circuits for an open or short. Refer to Circuit Testing and Wiring Repairs in Diagnostic Aids. Component Tests and General Diagnostics
2. No low level audio output from the radio-Test for any AC voltage between the appropriate low level output circuits at the amplifier harness connector, disconnected with the radio volume adjusted to an audible level. If no A/C voltage is present, replace the radio. Refer to Radio Replacement.
3. No audio output from the amplifier-Test for any A/C voltage between the appropriate speaker output circuits at the speaker harness connector, disconnected with the radio volume adjusted to an audible level. If A/C voltage is present, replace the speaker. If no A/C voltage is present, replace the amplifier. Refer to Amplifier Replacement.

Speakers - One Channel Inoperative

Important: The following information lists the most probable cause of the concern to the least probable cause. If the list leads to the replacement of a component, always inspect for a poor connection before proceeding with replacement. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Diagnostic Aids. Component Tests and General Diagnostics

Important: The following procedure assumes all speakers are operative for all modes of operation except digital radio.

With RPO U2K

* Audio signal circuit open-Test the appropriate audio signal circuit between the radio and digital radio receiver (DRR) for an open, short to ground, or short to battery. Refer to Circuit Testing and Wiring Repairs in Diagnostic Aids. Component Tests and General Diagnostics
* No audio output from the DRR-Measure the voltage from the DRR audio signal circuit with the radio ON. Replace the DRR if no voltage is measured.
* No audio input to the radio-Measure the voltage from the radio audio signal circuit with the radio ON. Replace the radio if voltage is measured and symptom is still present.
* After replacing the radio, perform the VIN Relearn procedure. On the scan tool, go to Module Replacement/Setup in Vehicle Control Systems and select Radio.