Air Bag Indicator Circuit Malfunction

Air Bag Indicator Circuit Malfunction

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provide an overview of each diagnostic category.

Circuit/System Description

When the ignition is turned ON, the instrument panel cluster (IPC) flashes the AIR BAG indicator 7 times. The inflatable restraint sensing and diagnostic module (SDM) performs diagnostic tests on the SIR system and then commands the IPC to turn the AIR BAG indicator OFF if no SIR malfunction exists. The AIR BAG indicator is controlled by the SDM via serial data communications. If the ignition 1 voltage is outside of the normal operating voltage range 9-16 volts, the SDM will command the IPC to turn the AIR BAG indicator ON with no DTCs present then disables all deployment loops.

Diagnostic Aids

A DTC B1370 may set if the ignition 1 circuit is outside the 9-16 volts range.

Circuit/System Testing

1. Ignition ON, use the scan tool to request the SIR data list display. Observe the Battery Voltage Parameter. The battery voltage on the scan tool should read 9-16 volts.

• If the voltage is less than 9 volts, refer to Diagnostic System Check - Vehicle. Initial Inspection and Diagnostic Overview

2. Ignition ON, monitor the IPC. The SIR warning indicator should flash then turn OFF. Verify that the SIR warning indicator flash and then turn OFF.

• If the SIR warning indicator continually flashes then reprogrammed the SDM.

3. Using the scan tool, go to Body and Accessories, then go onward to Special Functions to Instrument Panel Cluster, and then go to Display Test. In the Display Test mode you can turn ON or OFF all the instrument panel indicators when commanded ON. Commanded the IPC indicators ON. The Air Bag indicator should turn ON.

• If the Air Bag indicator does not turn ON, replace the IPC.

4. If the scan tool commands the Air Bag indicator ON and OFF, replace the SDM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

* SIR/SRS Wiring Repairs
* Control Module References for IPC and SDM replacement, setup, and programming Verification Tests