Instrument Panel Accessory Trim Plate Replacement - Left Side

Instrument Panel Accessory Trim Plate Replacement - Left Side

Removal Procedure

1. Remove the left closeout/insulator panel.
2. Remove the knee bolster trim panel.




3. Remove the 2 headlamp trim plate retaining nuts.
4. Use a plastic flat bladed tool in order to release the retaining clips.
5. Remove the headlamp trim plate from the instrument panel (I/P).

Installation Procedure




1. Install the headlamp trim plate to the I/P, ensuring the retaining clips are fully seated.

Notice: Refer to Fastener Notice.

2. Install the 2 headlamp trim plate retaining screws.

Tighten the screws to 2.5 N.m (22 lb in).

3. Install the knee bolster trim panel.
4. Install the left closeout/insulator panel.