Instrument Cluster / Carrier: Service and Repair

Instrument Cluster Replacement

Removal Procedure

1. Remove the left closeout insulator panel.
2. Remove the knee bolster trim panel.
3. Remove the instrument panel cluster (IPC) bezel.




4. Remove the screws retaining the IPC to the I/P.
5. Partially remove the IPC from the I/P in order to gain access to the electrical connector.
6. Disconnect the electrical connector from the IPC.
7. Remove the IPC from the I/P.

Installation Procedure




1. Position the IPC to the I/P.
2. Connect the electrical connector to the IPC.
3. Install the IPC to the I/P.

Notice: Refer to Fastener Notice.

4. Install the screws to the instrument panel cluster.

Tighten the screws to 2.5 N.m (22 lb in).

5. Install the IPC bezel.
6. Install the knee bolster trim panel.
7. Install the left closeout insulator panel.
8. If installing a new IPC, program the IPC.