Sunroof Motor With Control Unit - Installation

INSTALLATION

NOTE: Before installing a new motor/module or the original motor/module ensure that the sunroof glass panel is in the FULLY CLOSED POSITION. If sunroof glass panel is not in the FULLY CLOSED POSITION, Power Sunroof Timing.

1. Ensure that sunroof assembly is in the FULLY CLOSED position before mounting the motor/module. If not in the fully closed position Power Sunroof Timing.
2. Place motor/module into position on the sunroof housing and install attaching screws. Tighten the screws to 3.5 Nm (31 in. lbs.) torque.
3. Connect the motor/module, and sunroof switch wire connectors.
4. Install sunroof glass panel Installation.
5. Connect the battery negative cable.
6. Perform the motor/module initialization procedure, Initialization.
7. Verify sunroof operation and alignment, and adjust as necessary. Adjustments.
8. Disconnect and isolate battery negative cable.
9. Installing the headliner Headliner - Installation.
10. Install sunroof opening trim lace. Installation.
11. Install the sunroof switch, Sunroof Switch - Installation.
12. Install the map lamps/mini console, Installation.
13. Install sun visors Sun Visor - Installation.
14. Install A-pillar trim A-Pillar Trim Panel-Installation.
15. Connect the battery negative cable.