A. Remove Driver Seat Assembly

1. Position the driver's seat far enough forward to gain access to the rear mounting bolts on the floor.





2. Remove the four (4) bolts that attach the seat to the floor (Figure 1).

3. Adjust the seat to the full up and full forward position.

4. Disconnect the driver seat wiring Figure 1 harness from the body wiring harness (Figure 1). Secure the seat harness to the seat adjuster to prevent damage during removal.

5. Cover the driver's door sill with a shop cloth or fender cover to prevent scratching during seat removal.

6. Remove the seat assembly from the vehicle and place it on a clean work surface.

7. Remove the seat belt buckle attaching bolt and then remove the seat belt buckle assembly and set it aside.

8. Remove the four (4) side shield attaching screws.

9. Disconnect the seat switch electrical connector and set the side shield/switch assembly aside.





10. Remove the two (2) recliner-to-seat back attaching bolts (Figure 2).

11. Remove the two (2) seat back pivot bolts (Figure 2).

12. Remove the seat back assembly and set it aside.

13. Cover the seat cushion, then turn the cushion and adjuster assembly over cushion side down.

14. Remove the push4n wiring harness fasteners from the seat cushion.





15. Remove the four (4) seat adjuster-to- seat cushion bolts (Figure 3).

16. Separate the seat adjuster from the seat cushion and set the seat cushion aside.

17. Place the seat adjuster on the bench with the four feet on the bench.