Rear Seat Back

REMOVAL
1. Remove rear seat cushion.

Rear Inner Seat Belt Assembly:

2. Remove rear inner seat belt assembly.

Rear Seat Back:

3. Pull bottom of rear seat back forward until seat back brackets clear studs on floor pan.
4. Push upward on rear seat back and disengage hooks holding seat back to rear seat back support.
5. Separate rear seat back from vehicle.

INSTALLATION
1. Position rear seat back in vehicle.
2. Tilt rear seat back rearward and raise seat back above retaining brackets on rear seat back support.
3. Lower rear seat back until center loop begins to engage.
4. Lower rear seat back and push rearward on outboard corners of seat back to engage outboard hooks to brackets on rear seat back support.
5. Push downward on rear seat back until all hooks are fully engaged into retaining brackets.
6. Install rear inner seat belt assembly
7. Install rear seat cushion.

NOTE: Torque specification for rear inner seat belt assembly is 40 Nm (350 in. lbs.).