Window Track: Service and Repair

Rear Vertical Guide Bar

Rear Vertical Guide Bar:

REMOVAL
1. Remove door trim panel and watershield.
2. Remove nut holding top of guide bar to inner door panel.
3. Using a suitable allen-wrench, hold jack screw stationary while removing nut holding bottom of guide bar to inner door panel.
4. Separate guide bar from vehicle and remove through access hole in inner door panel.

INSTALLATION
1. If a new guide bar is being installed, preset bottom jack screw using old guide bar as a reference.
2. Position rear guide bar on vehicle.
3. Using a suitable allen-wrench, hold jack screw stationary while installing nut holding bottom of guide bar to inner door panel.
4. Install nut holding top of rear guide bar to inner door panel.
5. Verify glass fit and operation. Adjust door glass as necessary
6. Install door trim panel and watershield.