Overhaul

The content of this article reflects changes called for in TSB 26-04-96.





REMOVAL
1. Note the position of the output shaft bearing. The bearing is not identical end to end. Install Bearing with large diameter cage facing outward. Remove caged roller bearing from output bearing race.





2. Remove screws at output bearing retainer strap.





3. Install tool #J-36038, or equivalent and slide hammer. Tighten tool to output bearing race.





INSTALLATION
1. Line up output bearing race to race bore.
2. Insert tool #C-4628 w/C-4171, or equivalents into output bearing race. Tap race into bore. Position bearing retaining strap. Tighten bolts to 11 Nm (115.2 inch lbs.). Install bearing with large diameter cage facing outward.