Verification Test VER-1A - No Start Verification Test

If the PCM has been replaced, do the following:

Important Note: If the Powertrain Control Module has been changed and the correct VIN and mileage have not been programmed, a DTC will be set in the ABS, Airbag and SKIM modules. In addition, if the vehicle is equipped with a Sentry Key Immobilizer Module (SKIM), Secret Key data must be updated to enable starting.

For ABS and Airbag Systems:
ACTION:
1. Enter correct VIN and Mileage in PCM.
2. Erase codes in ABS and Airbag modules.

For SKIM Theft Alarm:
ACTION:
1. Connect the DRB to the data link connector.
2. Go to Engine, Misc.. and place the SKIM in secured access mode, by using the appropriate PIN code for this vehicle.
3. Select Update the Secret Key data, data will be transferred from the SKIM to the PCM (this is required to allow the vehicle to start with the new PCM).
4. If three attempts are made to enter secured access mode using an incorrect PIN, secured access mode will be locked out for one hour. To exit this lock out of mode, leave the ignition key in the Run/Start position for one hour. Ensure all accessories are turned off. Also monitor the battery state and connect a battery charger if necessary.

Continue Below.

If the PCM has not been replaced, do the following:
Inspect the vehicle to ensure that all engine components are connected. Reassemble and reconnect components as necessary.

Inspect the engine oil for contamination. If it is contaminated, change the oil and filter.

Attempt to start the engine.

If the engine is unable to start, look for any Technical Service Bulletins that may relate to this condition. Return to DTC TEST if necessary.

The repair is now complete.