Power Window Switch: Service and Repair

MASTER SWITCH
REMOVAL
1. Remove driver's door trim panel.
2. Remove three mounting screws.
3. Remove switch and disconnect wire connector.

INSTALLATION
- For installation, reverse the above procedures.

PASSENGER SWITCH
REMOVAL
1. Remove passenger door trim panel.
2. Disconnect switch wire connector.
3. Using a trim stick (special tool #C-4755), gently pry out switch from bezel being careful not to damage bezel. First, insert the trim stick into the switch pocket in the flush side to release that side from the pocket. Use only enough force on the trim stick to permit the switch to be released from the pocket, and avoid twisting the stick to prevent damage to the switch or plastic pocket.

Passenger Power Window Switch:

NOTE: The connector is flush with one side of the switch housing.

4. After the flush side is released, release the non-flush side with similar care.

NOTE: Releasing the non4lush side first will make the flush side less accessible requiring extra force to remove.

INSTALLATION
- For installation, reverse the above procedures.