Body Control Module: Service and Repair

REMOVAL
1. With the Junction Block/BCM removed from the vehicle.
2. Remove the four BCM attaching screws from the Junction Block.
3. Disconnect BCM from the Junction Block.

NOTE:
- The Remote Keyless Entry (RKE) module is attached to the BCM with three screws. This must be transferred (if equipped) to the new BCM.

- If the BCM is replaced, the Vehicle Theft / Security System (VTSS (it equipped)) must be enabled in the new BCM via the DRB lll� in order to start the vehicle.

INSTALLATION
For installation, reverse the above procedures. Ensure that the wire terminals and connectors are in good condition and connectors are properly installed when reinstalling Junction Block / BCM.

REMOVAL AND INSTALLATION
For service of the Body Control Module (BCM), refer to Instrument Panel and Systems for Replacement.

NOTE: If the BCM is replaced, the VTSS must be enabled in the new BCM via the DRB lll�, in order to start the vehicle.