Cross-Member: Service and Repair

IMPORTANT: Follow the steps in the image and note the following procedures below. Refer to images for "" type references.

REMOVAL AND INSTALLATION

Removal Service Point
Centermember Assembly Removal





1. Set the special tool to the vehicle to support the engine assembly.
2. Remove the centermember assembly.

INSPECTION
- Check the crossmember for cracks or deformation.
- Check the bushings for cracks or deterioration.

CROSSMEMBER BUSHING REPLACEMENT
Crossmember Bushing A And B





1. Apply soapy water to the contact surface of the bush when press-fitting the bush.





2. Press-fit the bush so that the inner pipe projection is at the standard length.

Standard values:
Bushing A: 9.0 ± 1.0 mm (0.35 ± 0.04 inch)
Bushing B: 4.0 ± 1.0 mm (0.16 ± 0.04 inch)

Crossmember Bushing C





1. Use the special tool to drive out and press-fit the crossmember bushing C.





2. Press-fit the bush so that the inner pipe projection is at the standard length.

Standard value: 4.0 ± 0.5 mm (0.16 ± 0.02 inch)