Connecting Rod and Bearing-Fitting

Fig. 19

1. Follow the procedures in the Standard Service Procedures for Measuring Main Bearing and Connecting Rod Bearing Clearances. (Fig. 19). Refer to Engine Specifications.
2. Tighten connecting rod nuts to 51 Nm (37 ft. lbs.).
3. Remove connecting rod cap and measure Plastigage (Fig. 19). Refer to Engine Specifications

CAUTION: Do not rotate crankshaft or the Plastigage may be smeared.

CONNECTING ROD SIDE CLEARANCE





Fig. 20

Using a feeler gauge, check connecting rod side clearance (Fig. 20). Refer to Engine Specifications.