Manual Transmission

CONSOLE

REMOVAL

1. Remove the shifter boot.
2. Remove screws attaching the forward end of the console to shifter bracket.
3. Remove screws attaching rearward end of console to clips in floor bracket.
4. Fully engage parking brake.
5. Pull floor console up off of the floor bracket.
6. Disconnect the electrical connectors and remove the console.

INSTALLATION

1. Position console in vehicle.
2. Connect wire connector for floor console accessories at floor pan.
3. Verify that the rear locator pin on the bottom of the storage bin is engaged to the slot in the body bracket and the front pin is engaged to the shift mechanism.
4. Install screws, next to floor shifter and in console storage compartment, holding floor console to brackets on floor pan.
5. Connect transmission range indicator bezel wire connector on shifter mechanism.
6. Install lighted transmission range indicator letter bezel.
7. Install shift lever knob and tighten set screw on front of shifter knob.