Installation-1.6L Engine

INSTALLATION-1.6L ENGINE





1. Install the return hose onto the power steering pump inlet while positioning the hose in the proper direction. Slide the hose clamp into position on the fluid reservoir and attach it. Be sure hose clamp in installed past bead on fluid reservoir fitting.
2. Align the guide on the rear of the reservoir with the mounting bracket and push reservoir downward until reservoir clicks into place in the bracket. Guide the reservoir lower port into the supply hose as the reservoir is installed.
3. Slide the hose clamp into position on the fluid reservoir and attach it. Be sure hose clamp in installed past bead on fluid reservoir fitting.
4. Fill the fluid reservoir to the proper level with the correct Mopar power steering fluid or equivalent.
5. Perform the POWER STEERING PUMP INITIAL OPERATION procedure.
6. Check for fluid leaks at all hose connections.