Control Module: Service and Repair
REMOVALNOTE: If Transmission Control Module (TCM) is being replaced with a new or replacement unit, the Quick Learn procedure must be performed. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/TRANSMISSION CONTROL MODULE - STANDARD PROCEDURE)
1. Raise deck lid.
2. Disconnect battery negative cable.
3. Loosen 60 way retaining screw, located in the center of the 60 way connector. Disconnect connector.
Fig.7 Transmission Control Module:
4. Remove transmission control module mounting screws and lift module from vehicle (Fig. 7).
INSTALLATION
NOTE: If transmission control module is being replaced with a new or replacement unit, Quick Learn procedure must be performed. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/TRANSMISSION CONTROL MODULE - STANDARD PROCEDURE)
1. Install transmission control module and tighten mounting screws (Fig. 7).
2. Install 60 way connector. Tighten 60 way retaining screw to 4 Nm (35 in. lbs.).
3. Connect battery negative cable.
4. If TCM was replaced, perform the Quick Learn procedure. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/TRANSMISSION CONTROL MODULE - STANDARD PROCEDURE).