Operation CHARM: Car repair manuals for everyone.
Home >> Chrysler >> 2002 >> Prowler V6-3.5L VIN G >> Repair and Diagnosis >> Wiper and Washer Systems >> Relays and Modules - Wiper and Washer Systems >> Wiper Control Module >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Wiper Control Module: Service and Repair

REMOVAL
1. Open hood.
2. Disconnect and isolate the battery negative cable.

Fig.14 Wiper Motor And Linkage Module:




3. Remove wiper arms and blades, disconnect hoses from in-line connectors. Be sure that the in-line connector is saved.
4. Remove engine compartment hood.
5. Remove upper hood side panel left side.
6. Remove hood hinge.
7. Remove the cowl trim cover and disconnect the washer hose.
8. Remove the two braces.
9. Disconnect the motor wire harness connector.
10. Remove three module mounting screws.
11. Slide the module assembly out the left of the cowl using care not scratch the surface of the vehicle.

INSTALLATION
1. Position the module in the cowl.
2. Install the three mounting screws. Tighten the motor assembly mounting screws to 1.7 to 2.26 Nm (15 to 20 in. lbs.) torque.
3. Connect the wire harness connector.
4. Install the two module braces.
5. Install the cowl trim cover and connect the washer hoses.
6. Install the hood hinge.
7. Install the upper hood left side panel.
8. Install the engine compartment hood.
9. Install wiper arms.
10. Connect the battery negative cable.
pro multis · About Operation CHARM