Control Module Pinout Values

CHECK AT ABS-ECU

TERMINAL VOLTAGE CHECK CHART
1. Measure the voltages between terminals (16) and (19) (ground terminals) and each respective terminal.





2. The terminal layouts are shown in the illustrations.

NOTE: Do not measure terminal voltage for approximately three seconds after ignition switch is turned "ON." The ABS-ECU performs the initial check during that period.

RESISTANCE AND CONTINUITY BETWEEN HARNESS-SIDE CONNECTOR TERMINALS
1. Turn the ignition switch to the "LOCK" (OFF) position and disconnect the ABS-ECU connector before checking resistance and continuity.





2. Check between the terminals indicated in the table.

3. The terminal layouts are shown in the illustration.