System Specifications

Procedure for Checking Fluid Level

The fluid level in the automatic transaxle should be checked whenever the vehicle is serviced. Operation with an improper fluid level will greatly reduce the life of the transaxle and of the fluid.

To check the fluid level properly, the following procedure must be used:

- The vehicle must be on level ground.

- The engine should be running at curb idle speed for a minimum of 60 seconds.

- Fully apply parking brake.

- Place the gear selector momentarily in each gear position ending with the lever in P (PARK).

- Wipe the dipstick clean and reinsert it until seated. Remove the dipstick and note reading.

- If the fluid is cold (27 °C / 80 °F), the reading should be in the cross hatched area marked COLD, (between the lower two holes in the dipstick).

- If the fluid is hot (82 °C / 180 °F), the reading should be in the cross hatched area marked HOT, (between the upper two holes in the dipstick).

- If the fluid level is warm, the fluid level should be between the lower two holes marked WARM.

- If the fluid level shows low, add sufficient transmission fluid to bring to the proper level.

CAUTION: Do not overfill. Dirt and water in the transmission can cause serious damage. To prevent dirt and water from entering the transmision after checking and replenishing the fluid, make certain that the dipstick cap is properly reseated.