Power Door Lock Switch: Testing and Inspection

1. Remove door trim panel. Refer to Body Door - Front, Trim Panel, REMOVAL and INSTALLATION.
2. Disconnect wire connector from back of door lock switch.
3. Depress switch to LOCK position.

Door Lock Switch Continuity:

Fig.2 Door Lock Switch:

4. Using an ohmmeter, test switch resistance between Pins 2 and 3. Refer to the DOOR LOCK SWITCH CONTINUITY test and.
5. Depress switch to UNLOCK position.
6. Test resistance between Pins 2 and 3.
7. Test resistance between pins 2 and 3 while switch is in its normal unactuated mode.
8. If resistance values are not within the parameters shown replace the door lock switch.