Operation CHARM: Car repair manuals for everyone.
Home >> Chrysler >> 2003 >> Sebring Convertible L4-2.4L VIN X >> Repair and Diagnosis >> Body and Frame >> Interior Moulding / Trim >> Console >> Service and Repair >> Procedures >> Floor Console
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Floor Console





REMOVAL





1. Raise parking brake lever as high as possible.
2. Move transmission shifter to neutral position.
3. Loosen set screw on front of shifter knob and remove shift lever knob.

NOTE: Do not use a trim stick or tool to remove transmission range indicator.

4. Remove transmission range indicator bezel by squeezing the sides slightly and lifting up until the locking tabs are free of the floor console.
5. Disconnect transmission range indicator bezel wire connector on the underside of bezel.
6. Remove screws, next to floor shifter and in console storage compartment, attaching floor console to brackets on floor pan.
7. Disconnect wire connector for floor console accessories at floor pan.
8. Remove console from vehicle.

NOTE: The grip portion of the parking brake lever will only fit through the wider lower portion of the slot in the floor console.

INSTALLATION
1. Position console in vehicle.
2. Connect wire connector for floor console accessories at floor pan.
3. Verify that the rear locator pin on the bottom of the storage bin is engaged to the slot in the body bracket and the front pin is engaged to the shift mechanism.
4. Install screws, next to floor shifter and in console storage compartment, holding floor console to brackets on floor pan.
5. Connect transmission range indicator bezel wire connector on shifter mechanism.
6. Install lighted transmission range indicator letter bezel.
7. Install shift lever knob and tighten set screw on front of shifter knob.
pro multis · About Operation CHARM