Installation

INSTALLATION

NOTE: If valve body assembly is being replaced or reconditioned, it is necessary to perform the TCM Quick Learn Procedure.








1. Install valve body assembly to transaxle (Fig. 358). Install and torque valve body-to-transaxle case bolts (Fig. 359) to 12 Nm (105 in. lbs.).





2. Install transaxle oil filter (Fig. 360). Inspect the O-ring and replace if necessary.








3. Ensure the transaxle oil pan and transaxle case sealing surfaces are clean and dry. Install an 1/8" bead of Mopar ATF RTV (MS-GF41) to the oil pan and install (Fig. 361). Torque oil pan-to-transaxle case bolts (Fig. 362) to 19 Nm (165 in. lbs.).
4. Lower vehicle.
5. Connect transmission range sensor connector.
6. Install manual valve lever to manual shaft.
7. Install gearshift cable to manual valve lever.
8. Connect battery negative cable.
9. Fill transaxle with Mopar ATF +4 Transmission fluid.