Fog/Driving Lamp: Service and Repair

FOG LAMP UNIT

REMOVAL

Fog Lamp:

1. Remove fasteners attaching lower splash shield to gain access to the rear of the fog lamp.
2. Disconnect wire connector from fog lamp.
3. Remove nuts attaching fog lamp to fascia.
4. Remove lamp from fascia. The lower horn may need to be removed for easier fog lamp unit removal.
5. Remove the two fasteners attaching the outboard end of the fascia to the fender.
6. Rotate fog lamp unit forward, up, and out.

INSTALLATION

CAUTION: Do not touch the glass of halogen bulbs with fingers or other possibly oily surface, reduced bulb life will result.

1. Rotate fog lamp unit into position.
2. Place fog lamp unit into position.
3. Ensure that the three locating tabs molded into the fog lamp adapter are seated in the three matching fascia slots.
4. Install nuts attaching fog lamp to fascia.
5. Connect wire connector to the fog lamp.
6. Install horn if removed.
7. Install two fasteners to hold the outboard end of the fascia to the fender.