Standard Procedure - Fluid Level Checking

STANDARD PROCEDURE - FLUID LEVEL CHECKING

NOTE: The fluid required for this transaxle Mopar ATF +4 (Automatic Transmission Fluid). Use of improper or substitute fluids can cause shift problems and/or transaxle failure.

1. Raise vehicle on hoist.

Fig. 139 Transaxle Fluid Drain and Fill Plugs:

2. Remove transaxle fill plug (Fig. 139). Inspect fluid level. Fluid should be within 4.7 mm (0.188 in.) from bottom of filler hole.
3. If required, fill transaxle with suitable amount of ATF +4 (Automatic Transaxle Fluid).
4. Install fill plug and torque to 39-47 N.m (29-35 ft. lbs.) (Fig. 139).
5. Lower vehicle.