Rear Door Window Glass: Service and Repair
REAR DOOR GLASSREMOVAL
1. Remove door trim panel and inner belt weatherstrip.
2. Lower the window (1) to 50 mm (2 inches.) from bottom of travel.
3. Loosen bolts attaching rear lower run channel to inner door panel.
4. Remove rear run channels from door.
5. Loosen screws attaching window regulator (3) to glass (1).
6. Remove glass.
7. Lift door glass upward out of the opening at the top of door.
INSTALLATION
1. Lower door glass (1) through opening in top of door and into position in the window regulator (3).
2. Raise window glass (1) and regulator (3) to full up position.
3. Tighten screws attaching window regulator (3) to glass.
4. Install lower belt brackets.
5. Install inner door belt door trim panel and inner belt weatherstrip.
6. Install outer belt weatherstrip.
7. Operate window and check for interference. Adjust glass as necessary.