Driver Seat Switch

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the front door trim panel. Refer to the Body section for the procedure.
3. Disconnect the wire harness connector from the door module. Depress the retaining tab and pull straight apart.
4. Press in the four clips that secure the seat switch to the door trim panel.
5. Remove the power seat switch from the trim panel.


INSTALLATION
1. Position the seat switch onto the door trim panel. Press into place ensuring all four clips are engaged.
2. Reconnect the wire harness connector to the door module.
3. Install the front door trim panel. Refer to the Body section for the procedure.
4. Reconnect the battery negative cable.