Rear Door Window Motor: Service and Repair

REMOVAL

NOTE: Secure window in the UP position before removing motor.

1. Disconnect and isolate the battery negative cable.
2. Remove the rear door trim panel.
3. Remove the rear door speaker.
4. Remove the watershield.
5. Disconnect electrical harness wire connector from the motor.
6. Loosen window regulator mounting fasteners (do not remove).
7. Remove mounting fasteners and motor.

INSTALLATION
1. Install motor and mounting fasteners to regulator.
2. Install window regulator.
3. Connect electrical harness connector.
4. Install rear door trim panel.
5. Connect battery negative cable.