Front

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Hoist vehicle.
3. Unsnap the sensor link from the upper control arm (front) (1).
4. Disconnect the one electrical connector (4).
5. Remove the two speed nuts (3) to remove sensor and bracket (2).

INSTALLATION




1. Install the two retaining nuts (3) to the sensor and bracket (2).
2. Connect the one electrical connector (4).
3. Snap the sensor link onto the upper control arm (front) (1).
4. Remove the vehicle from the hoist.
5. Connect the battery negative cable.
6. Using a Scan Tool, calibrate the headlamp leveling system.