Washer Fluid Level Switch: Service and Repair

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Drain washer fluid from the reservoir and into a suitable clean container. This can be done by disconnecting the windshield washer hose from the front (outboard) washer pump and allowing the washer fluid to drain into a container through a temporary jumper hose connected to the front washer pump.
3. Remove the washer reservoir.




4. Remove the washer fluid level switch by pulling out of reservoir. Inspect the grommet and if installing a new switch, always use a new grommet.

INSTALLATION




1. Inspect grommet and if installing new switch, use a new grommet. Position the switch into opening and firmly press into place.




2. Install the washer reservoir.
3. Refill the reservoir with fluid drained previously.
4. Connect the battery negative cable.