Removal

ELECTROHYDRAULIC UNIT

REMOVAL





1. Move selector lever to position "P".
2. Raise and support the vehicle.
3. Remove the bolt (3) and screw (1) holding the heat shield (2) to the transmission.
4. Loosen the guide bushing and remove it from the transmission housing.





5. Disconnect the 13-pin plug connector (1). Turn the bayonet lock of the guide bushing (2) anti-clockwise.

Note: If the transmission fluid is burnt or contains abraded particles, the oil cooler lines and oil cooler must be flushed out.

6. Remove the transmission filter.





7. Unscrew the bolts (3) and remove electrohydraulic control module (2).