Fluid Level Check

STANDARD PROCEDURE - FLUID LEVEL CHECKING

NOTE: The fluid required for this transaxle is Mopar ATF+4 (Automatic Transmission Fluid). Use of improper or substitute fluids can cause shift problems and/or transaxle failure.

1. Raise vehicle on hoist.





2. Diesel Models: Remove engine compartment lower silencer (Fig. 140).





3. Remove transaxle fill plug (Fig. 139). Inspect fluid level. Fluid should be within 4.7 mm (0.188 inch) from bottom of filler hole.
4. If required, fill transaxle with suitable amount of ATF+4 (Automatic Transaxle Fluid).
5. Install fill plug and torque to 39 - 47 Nm (29 - 35 ft. lbs.) (Fig. 139).
6. Diesel Models: Install engine compartment lower silencer (Fig. 140).
7. Lower vehicle.