Air Cleaner Housing: Service and Repair

AIR CLEANER HOUSING
REMOVAL
1. Disconnect negative battery cable.
2. Disconnect inlet air temperature sensor electrical connector.
3. Disconnect fresh air makeup hose from throttle body air inlet hose.





4. Loosen hose clamp at throttle body air inlet hose. Remove hose from throttle body (Fig. 8).
5. Remove push pin securing air duct to upper radiator support.
6. Remove nut on bracket that holds air cleaner housing.
7. Pull air cleaner housing straight up off locating pins (Fig. 8).

INSTALLATION
1. Install air cleaner housing straight down on locating pins (Fig. 8).
2. Install nut on bracket that holds air cleaner housing and tighten.
3. Install push pin that secures air duct to upper radiator support.
4. Install throttle body air inlet hose to throttle body Tighten hose clamp.
5. Connect fresh air makeup hose.
6. Connect inlet air temperature sensor electrical connector.
7. Connect negative battery cable.