Sensor-Rear Wheel Speed
SENSOR-REAR WHEEL SPEEDREMOVAL
1. Raise and support vehicle.
NOTE: To release sensor connector from body wiring harness connector (1) in following step, move retaining clip (2) as indicated here, then pull sensor connector (3) outward.
2. Remove sensor connectors (3 and 4) from body wiring harness connector (1) located in luggage compartment floor pan (2).
3. Separate left sensor connector (4) from right sensor connector (3).
4. If removing left sensor, unclip sensor cable (3) from routing clip near body connector (1).
5. If removing left sensor, unclip sensor cable (1) from routing clips (2) along rear of crossmember near rear differential (3).
6. If removing left sensor, unclip sensor cable (2) from routing clip (1) above toe link mount on rear crossmember.
7. Unclip sensor cable (2) from routing clips (3) along toe link.
8. Unclip sensor cable at rear brake rotor shield (1).
9. Remove screw (2) fastening sensor head (3) to rear knuckle.
10. Remove wheel speed sensor.
INSTALLATION
1. Insert wheel speed sensor head (3) into mounting hole in rear of knuckle.
2. Install screw (2) fastening sensor head (3) to rear knuckle. Tighten Screw to 11 Nm (100 inch lbs.) torque.
3. Install sensor cable at rear brake rotor shield (1).
4. Clip sensor cable (2) to routing clips (3) along toe link.
5. If installing left sensor, clip sensor cable (2) to routing clip (1) above toe link mount on rear crossmember.
6. If installing left sensor, clip sensor cable (1) to routing clips (2) along rear of crossmember near rear differential (3).
7. If installing left sensor, clip sensor cable (3) to routing clip near body connector (1).
8. Match left sensor connector (4) to right sensor connector (3) to make one connector.
9. Insert sensor connectors (3 and 4) into body wiring harness connector (1) located in luggage compartment floor pan (2). When installing connector, make sure retaining clip on body connector is properly in place and sensor connector cannot be pulled out.