Oil Line: Service and Repair
COOLER & LINES-OILREMOVAL
1. Drain cooling system.
2. Raise vehicle on hoist.
3. Disconnect coolant hoses (2) from oil cooler (4).
4. Remove oil filter (3).
5. Remove oil cooler attaching fastener from center of oil cooler (4).
6. Remove oil cooler (4).
INSTALLATION
1. Install oil cooler (4).
NOTE: The cut out section of the oil cooler seal retainer flange (top), must be aligned with the tab on the oil pan. The oil cooler must be prevented from turning during the tightening sequence.
2. Install oil cooler (4) attaching fastener and tighten to 61 Nm (45 ft. lbs.).
3. Install oil filter (3).
4. Connect coolant hoses (2) to oil cooler (4).
5. Lower vehicle.
6. Fill cooling system.
7. Start engine and check for leaks.
8. Check engine oil and add as needed.