Parking Assist Control Module: Service and Repair

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Peel back the right inner trunk carpet to expose the Park Assist Module (2).




3. On the wagon, the module will be behind the right side D-pillar trim and is attached the same as the sedan.




4. Remove the two attaching screws (1) and separate the module (2) from the vehicle.
5. Disconnect the Park Assist Module (2) electrical connector (1).

INSTALLATION




1. Connect the Park Assist Module electrical connector.




2. Position the Park Assist Module (2) and install the two attaching screws (1). Torque screws to 3.5 N.m (30 in.lbs.).
3. Reposition the trunk carpet.
4. Connect the battery negative cable.