Power Steering Pressure Switch: Service and Repair
SWITCH-POWER STEERING PRESSUREREMOVAL
NOTE: Before proceeding, Refer to Steering/Service Precautions.
1. Raise and support the vehicle.
2. Locate the power steering fluid pressure switch (3) on the back side of the power steering gear (2).
3. Release the locking tab on the wiring harness connector (1) at the pressure switch, then disconnect the wiring harness connector.
NOTE: When removing and installing the power steering pressure switch, use a deep well socket. The deep well socket will prevent damage to the plastic electrical connector area of the power steering fluid pressure switch.
4. Unscrew and remove the power steering fluid pressure switch from the power steering gear.
INSTALLATION
1. By hand, screw the power steering pressure switch into the power steering gear until it is fully seated. Tighten the power steering pressure switch to 8 Nm (70 inch lbs.).
2. Connect the wiring harness connector (1) to the power steering fluid pressure switch (3). Be sure the locking tab on the wiring harness connector is securely latched following installation.
3. Lower the vehicle.
4. Adjust the power steering fluid level in the reservoir to the correct fluid level.
5. Start the engine and turn the steering wheel several times stop-to-stop to bleed any air from the fluid in the power steering system. Stop the engine, check the fluid level, and inspect the system for leaks.