Backup Lamp Switch: Service and Repair

T350 MANUAL TRANSAXLE

BACK-UP LAMP SWITCH

REMOVAL
(1) Lift vehicle on hoist.

Fig. 49 Back-Up Lamp Switch:

(2) From bottom side of vehicle, disconnect back-up lamp switch connector (1) (Fig. 49).
(3) Unscrew switch (2) from transaxle.

INSTALLATION

Fig. 50 Back-Up Lamp Switch:

Install back-up lamp switch (2) (Fig. 50). Teflon tape or equivalent must be used on switch threads. Tighten switch to 24 Nm (18 ft. lbs.) torque.

CAUTION: Do not overtighten switch.

(1) Connect back-up lamp switch connector (1).
(2) Lower vehicle.
(3) Verify back-up lamp operation.