Assembly

T350 MANUAL TRANSAXLE

SYNCHRONIZER

ASSEMBLY

Fig. 121 Synchronizer Assembly:

(1) Position synchronizer hub (5) (Fig. 121) onto a suitable holding fixture (input shaft). The synchronizer hubs (5) are directional. The hubs must be installed with the U facing upward.
(2) Install springs (4) into hub slot.

Fig. 122 Synchronizer Balls:

(3) Insert key (3) (Fig. 122) into hub (2) and spring.
(4) Apply petroleum jelly to the hole in the key Insert balls (4) into each key

Fig. 123 Synchronizer Sleeve:

(5) Slide sleeve (1) (Fig. 123) over the hub and depress balls as you carefully slip the sleeve into position.

Fig. 124 Keys In Hub:

(6) Line up stop ring tang over the keys in the hub, install stop rings, center the keys (3) (Fig. 124) and balls (4) by pushing on both stop rings.