Removal

REMOVAL




1. Remove the watershield. Refer to Front Door Panel.

2. Separate the inner belt molding from the mounting flange from the rear to the front.

3. Insert special tool #9093 (2) between the outer belt molding (1) and glass at the rear.

4. Push down on outer belt molding (1) and rotate upper part of tool (2) outward from vehicle then lift up on molding (1) to disengage from locking tabs (3) working from back to front.

NOTE: Typical outer belt molding design shown.

5. Slide molding out from under the side view mirror and remove.




6. Temporarily install the window switch and position the glass (1) to gain access to the regulator nuts (4).

7. Remove the nuts (4) and remove the glass (1).