Operation CHARM: Car repair manuals for everyone.
Home >> Chrysler >> 2007 >> Aspen 4WD V8-5.7L >> Repair and Diagnosis >> Transmission and Drivetrain >> Differential Assembly >> Service and Repair >> Front Axle - C205F >> Differential >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation






INSTALLATION





NOTE: If replacement differential bearings or differential case are replaced, Refer to adjustments for Differential Bearing Preload and Gear Backlash procedures.

1. Install Spreader W-129-B (2) with the Adapter Plates 8142A and install the safety hold-down clamps. Tighten the tool turnbuckle finger-tight.
2. Install a Pin C-3288-B at the left side of the differential housing. Attach Dial Indicator C-3339 (1) to pilot stud. Load indicator plunger against the opposite side of the housing and zero the indicator.
3. Spread housing and measure the distance with the dial indicator.

CAUTION: Never spread housing over 0.50 mm (0.020 in). Failure to follow these instructions will damage the housing.

4. Remove dial indicator (1).




5. Install differential case (2) in the housing. Ensure differential bearing cups (3) remain in position on the bearings and the differential preload shims are seated in the housing. Tap differential case to ensure bearings cups are seated in the housing.
6. Install bearing caps to their original locations and loosely install cap bolts.
7. Remove case spreader (1).
8. Tighten the bearing cap bolts to 61 Nm (45 ft. lbs.).
9. Install differential.
pro multis · About Operation CHARM