Removal

REMOVAL





1. Disconnect the negative battery cable (2). Wait two minutes for the system capacitor to discharge before further service.





2. Un-snap and remove the carpeted floor mat.

3. Un-tuck the carpeting in the passenger footwell, and fold the carpet down to expose the foam insulation.

4. Remove the foam insulating panel.





NOTE: It is not necessary to remove the electrical connectors to rotate the base plate in the passenger footwell.

5. Remove the plastic retaining nuts (1) from the floor panel and rotate the base plate exposing the passenger seat occupant simulator.





6. Remove the plastic tie, and disconnect the passenger seat occupant simulator harness connector. Remove the passenger seat occupant simulator (1).