Removal

REMOVAL

WARNING: Review safety precautions and warnings before performing this procedure. Failure to follow the warnings and cautions could result in possible personal injury or death.






1. Disconnect and isolate the negative battery cable.

2. Recover the refrigerant from the refrigerant system.

3. Raise and support the vehicle.

4. Disconnect the wire harness connector (1) from the A/C high pressure switch (2) located at the rear of the A/C compressor (3).

5. Using snap ring pliers (Special Tool C-4574 or equivalent), remove the internal snap ring that secures the A/C high pressure switch to the A/C compressor.

6. Remove the A/C high pressure switch from the A/C compressor and remove and discard the O-ring seal.