Seat Cover: Service and Repair
THIRD ROW SEAT CUSHION/COVERREMOVAL
1. Open liftgate.
2. Remove rear floor stowage bin.
3. Remove third row seat.
Fig. 58:
4. Remove two bolts (on outboard side of seat) attaching drive link assembly (Fig. 58).
5. Remove drive link assembly.
Fig. 59:
6. Remove two bolts attaching front cushion pan to link and riser assemblies (Fig. 59).
Fig. 60:
7. Remove cushion assembly by sliding the front links off of the riser pins and twisting the cushion assembly to disengage the rear sliders from the riser tracks (Fig. 60).
Fig. 62:
Fig. 63:
9. Remove seat cushion cover and foam pad from the seat pan (Fig. 62) and (Fig. 63).
10. Remove seat cushion cover from foam pad.
INSTALLATION
Fig. 62:
1. Place seat cushion cover onto cushion foam pad (Fig. 64).
2. Install seat cushion cover and foam pad seat pan (Fig. 63).
Fig. 61:
3. Engage J-straps (Fig. 62) and (Fig. 61).
4. Install cushion assembly onto the seat risers.
5. Install cushion assembly by sliding the front links onto the riser pins and twisting the cushion assembly to engage the rear sliders onto the riser tracks (Fig. 60).
6. Install two bolts attaching front cushion pan to link and risers (Fig. 59). Tighten to 29 N.m (21 ft.lbs.) torque.
7. Install drive link assembly.
8. Install two bolts attaching drive link assembly (Fig. 58). Tighten to 10 N.m (7 ft.lbs.) torque.
9. Install third row seat.
10. Install rear floor stowage bin.
11. Close liftgate.