Removal

REMOVAL





CAUTION: Do not swap BCM's between vehicles or with BCM's that are in stock.

NOTE: If the BCM is replaced, it must be programmed using a scan tool and DealerCONNECT(R).

1. Disconnect and isolate the battery negative cable.

2. Remove the lower instrument panel silencer.

3. Remove the knee blocker airbag.

4. Disconnect the 72-way bulkhead connector from the Body Control Module (BCM) (4) mounting assembly.

5. Move bulkhead wiring aside.

6. Disconnect the five wire connectors from the BCM.

7. Remove the four screws (2) holding the BCM to the bulkhead.

8. Remove the BCM from the mounting bracket.