Installation

INSTALLATION





1. With the aid of an assistant, support and position the deck lid (1) to the two upper hinge brackets (3) on the vehicle.
2. Install and tighten the two screws (2) that secure each upper hinge bracket to the deck lid. Tighten the screws to 28 Nm (21 ft. lbs.).




3. Carefully route the deck lid take out (2) of the body wire harness between the inner and outer deck lid panels.
4. Engage the wire grommet (1) into the hole near the right hinge on the underside of the deck lid.
5. Engage the two retainers (4) that secure the deck lid take out (2) of the body wire harness to the underside of the deck lid.




6. Reconnect the connector (2) of the body wire harness take out for the deck lid (1) to the latch connector receptacle (3).
7. Reinstall the cover over the latch on the inside of the deck lid. Installation.
8. Reconnect the battery negative cable.
9. Close the deck lid.
10. Adjust the deck lid hinge positions and upper overslam bumpers as necessary to achieve proper spacing and operation.