Installation

INSTALLATION





1. Position the slider sled (1) as shown and insert it into the lever arm (2).




2. Insert the slider bar (1) through the slider sled (2) as shown.




3. Place the slider bar onto the column by aligning the large holes in the mounting slots with the casting pins (1) on the column, then slide the slider bar (2) into mounted position.




4. Position the tilt and telescoping adjustment handle (2) over the column adjustment pin (on slider sled) and rotate the locking tab (3) rearward as shown latching the handle to the column. Make sure the tab snaps into locked position.




5. Install the steering column opening reinforcement (1).
6. Install the steering column opening cover. Steering Column Opening Cover - Installation
7. Test the steering column tilt and telescoping operation.