Installation

INSTALLATION





1. Lubricate the O-ring on the proportioning valve. If not new, replace the O-ring on the proportioning valve.
2. Install the proportioning valve (1 or 3) in its master cylinder (2) port. Tighten the proportioning valve to 27 Nm (20 ft. lbs.).




3. Install the brake tube (4 or 5) to the proportioning valve. Tighten the tube nut to 17 Nm (145 in. lbs.).




4. Remove the brake pedal holder.
5. Bleed the affected brake line. Brake Bleeding
6. Road test the vehicle to ensure proper operation of the brakes.